5. Mark the edges shown on template 2.
6. Using a right angle grinder with a cutting disk, cut the mower deck as marked from the
templates.
7. Use the right angle grinder with a grinding disk to smooth the rough edges that remain
after the cutouts are made.
Installing the Pulley Assembly
Parts Required
1
1. Loosen the tapping bolts on the existing mower-deck pulley. There should be a 5 mm (3/
16 inch) clearance between the bolt head and pulley.
2. Align the new pulley assembly so that the openings fit over the pulley bolt heads.
G431444
G431452
Pulley assembly
Page 2
Template 1
Mower deck
Template 2
Remove from the mower deck
Mower deck
Right angle grinder
3462-361 A