Table of Contents
Advertisement
Starting Up and Closing Down the System
$ System Start Up
Follow the steps outlined below to start up the system.
1. Install the optional board. (See page 31.)
2. Install the HDD for data. (See page 36.)
3. Connect the FC cable between the Fibre Channel
connectors [RAID] and [HOST].
4. Connect power cord and signal line.
Connect the power cord to AC power socket for the
power supply unit installed.
5. Turn the POWER switch on the front panel to ON.
When the power switch is set to ON, the power
supply LED above the switch lights.
6. Startup is completed when the channel status is
shown on the front panel display.
Check the setting of each channel.
Never turn off the power supply during startup.
Otherwise internal data might be destroyed.
7
¢ ¢
4 4
$ System Shutdown/Power Off
Follow the steps outlined below to shut down the
system and turn off the power. (See page 21.)
1. Refer to the display panel menu flowchart to display
the final setting menu (7).
Press cursor button [ # ] or [ 2 ], select SERVER
SHUTDOWN, and press the [SET] button.
<Wait a moment, please> is shown on the display.
Confirm that the display has changed from <Wait a
moment, please> to <It is now safe to turn off>,
then turn the power switch to OFF.
Never turn off the power supply while the unit is
running.
Otherwise internal data might be destroyed.
16
3 3
4 4
7
7
7
Advertisement
Table of Contents
