Table of Contents
Advertisement
Rack Mounting
Using the rack-mounting adapters provided, the unit can be mounted in a 19-inch standard rack. The following
slide rails and brackets are recommended for mounting.
O Slide rails (CC3001-99-0191), brackets (B-308): made by CHASIS TRAK
For details, consult your dealer.
1. Remove the four feet from the bottom of the unit.
O Take care to safeguard the unit from vibration and
impact.
2. Attach the inner members of the slide rails to the
unit.
O There is a limit to the length of the screws which
can be used for rack mounting.
Use the accessory screws (M4a10) for the slide
rails.
If any of the accessory screws are lost or
misplaced, use replacement screws that are less
than 10 mm long.
O Ensure the inner members are screwed in place at
the 4 locations on the left and right.
3. Attach the outer members of the slide rails and
brackets to the rack.
<Note>
Check that the height at the left and right is the
same.
4. Attach the rack-mounting adapters to the unit.
O Use the mounting screws provided with the rack-
mounting adapters to attach these adapters.
O Ensure the rack-mounting adapters are screwed in
place at the 2 locations on the left and right.
5. Release the inner member stoppers, and install the
unit in the rack. Once it has been installed, check
that it moves smoothly.
O Keep the temperature inside the rack to between
41°F to 95°F (5°C to 35°C).
O Bolt the rack securely to the floor so that it will not
topple over when this unit is drawn out.
O When an HDD is installed, the unit becomes
heavier on the front panel side, so be careful
when removing the unit.
O Do not move the unit while there is electrical flow,
as this could cause damage to the HDD or data.
12
Advertisement
Table of Contents
