Parts And Their Functions; Front Panel - Panasonic AJ-HDR150P Operating Instructions Manual

Parts and Their Functions

Front panel

9
7
5
4
3
WA RNI NG
A
POW ER
B
ON
HDD
OFF
F1
F2
F3
F4
F5
REC UE
EMR PLA CAN CEL
Y REM OTE
/LO CAL TC/
CTL
CTL RES
ET
FUN CTI ON
1 2 6
8
1 Power switch [POWER A]
This switch is used to turn the unit's [POWER A]
supply ON or OFF.
Before turning the power off, execute SHUTDOWN
from the display panel and wait for the display to
read: "It is now safe to turn off."
Turning the power off during operation may destroy
data or cause the hard disk drive to fail.
2 Power switch [POWER B]
This switch is used to turn the unit's [POWER B]
supply ON or OFF.
The unit has dual power supply system to avoid
any problems with the power supply.
If a problem arises with either POWER A or
POWER B, the unit operates with the other power
supply.
3 Power LED [POWER A]
This lights when power is supplied to POWER A.
It goes off when the power switches of both
POWER A and POWER B are at OFF.
Green LED: No anomalies
Red LED:
O There is something wrong with the output
voltage, cooling fan or power supply module
temperature.
O While the POWER B switch is at ON, the
POWER A switch has been turned to OFF or
the POWER A supply unit has not been
installed.
:
1
2
3
4
CH
;
4 Power LED [POWER B]
This lights when power is supplied to POWER B.
It goes off when the power switches of both
POWER A and POWER B are at OFF.
Green LED: No anomalies
Red LED:
O There is something wrong with the output
voltage, cooling fan or power supply module
temperature.
O While the POWER A switch is at ON, the
POWER B switch has been turned to OFF or
the POWER B supply unit has not been
installed.
5 WARNING LED [WARNING]
During SILENT-MODE:
The lamp turns orange and blinks whenever
something goes wrong with the unit.
In the event of a slight error, this lamp goes out
after the error log is checked.
In the event of a gross error, the lamp lights in red.
During ATTN-MODE:
The lamp turns orange and blinks whenever
something goes wrong with the unit. The error
display menu appears on the display panel and at
the same time, the alarm sounds.
To stop the alarm, press the [F3] button.
In the event of a gross error, the lamp lights in red.
6 HDD LED [HDD]
This lamp blinks when a built-in HDD has been
accessed. It blinks green when all the built-in HDDs
are operating normally, and lights in orange during
reconstruction. In the event of a problem with any
one of the HDD units (including those not yet
inserted), the lamp blinks red to give notice.
7 Display panel
Displays the status of channel selected with
channel select button, along with information on the
unit internals.
The display menu is changed by using function
button (8) or cursor button (9).
8 Function buttons [F1 F5]
Used when executing any of the functions shown in
the lower register of the display panel.
The operations allocated to each function on the
menu are carried out by pressing these buttons.
8