Samsung OfficeServ 7100 Technical Manual page 94

OfficeServ 7100
TECHNICAL MANUAL
4 CTI LINK OPTION
5 ITP DSP PARA
6 ITP TX GAIN/HSET
7 ITP RX GAIN/HSET
MMC: 841
1 ALIVE TIME: This is a EasySet link via LAN alive check
timer.
Sets CTI link via LAN option with the system.
0 SMDR REPORT: Sets YES or NO for SMDR data to CTI link via
LAN.
1 UCD REPORT: Sets YES or NO for UCD data to CTI link via
LAN.
2 ALIVE TIME: This is a CTI link via LAN alive check timer. If
this sets 0, the system will not check link alive.
Sets IP phone DSP parameters of system-wide.
0 M-FRAME: This value determines the transmission interval
time of VoIP packets generated by the IP phone. This data
is effective only when DOWN = SYS DATA in this MMC.
The range is 10~40 ms. Applies only to ITP to ITP calls
(when both ITPs are in same zone).
1 JITTER: Decides the minimum time to consider delay for
jitter adjustment. This data is effective only when DOWN =
SYS DATA in this MMC. The range is 10~90 ms. Applies
only to ITP to ITP calls (when both ITPs are in same zone).
2 TOS/DIFFSERV: An eight-bit binary value that will be utilized
by external routers, switches, etc(that optionally support
TOS/DIFFSERV-bit prioritization)-to identify the transport-
priority value of data packets generated by the IP phone.
This value can be left at default value(00000) if your
network infrastructure does not support this method of
bandwidth management. This data is effective only when
DOWN = SYS DATA in this MMC. Applies only to ITP to
ITP calls (when both ITPs are in same zone).
3 CONTROL: Determines data uses system-wide data or each
phone data for IP-based phone DSP control.
a) SYS BASE: System-wide data will be used.(MMC 841
data)
b) ITP BASE: Each phone data will be used.(MMC 840
data)
CODE C: Choose codec priority MGI or ITP .
Sets IP-based phone Handset TX gain value of each level.
Sets IP-based phone Handset RX gain value of each level.
PROGRAMMING
PART 2 APRIL 2007
0 SEC
-
NO
NO
300 SEC
-
10 ms
20 ms
all bits 0
SYS BASE
-
-