Samsung OfficeServ 7100 Technical Manual page 307

OfficeServ 7100
TECHNICAL MANUAL
On the Additional Information screen there is a list of 9 Stored Numbers. The first
5 of these numbers will be used for the Find me feature. When the system
attempts to locate the subscriber it will first attempt to call Stored Number 1,
then 2, then 3, and so on. Note that this is a supervised transfer, so if the call is
not answered the transfer will pull back and move to the next number. If all 5
calls go unanswered the caller will be sent to the Primary No Answer Greeting to
leave a message.
If the subscriber does answer at one of the Stored Numbers the voicemail will
announce the caller and ask if the call is accepted or rejected. If accepted the
caller will be transferred to the subscriber. If rejected the caller will be sent to the
subscriber's Primary No Answer Greeting.
Programming:
On the Authorization screen of the subscriber's Extension block change Find me
allowed to Yes.
Also set the Enabled box to the right of it to Yes, then click Save.
On the Additional Information screen set Stored Number 1 to the subscriber's
wireless extension.
Set Stored number 2 to the subscriber's remote office phone number.
Set Stored number 3 to the subscriber's cell phone number.
Set Stored number 4 to the subscriber's home office phone number and then
click Save.
8.1.8.4 Park Caller and Page Subscriber
Scenario:
A floor manager commonly walks to factory floor and is not near his phone to
hear it ringing, so he has requested a way to utilize the switch paging feature to
be alerted to new callers holding at his desk.
Planning:
We know that the voicemail has a Park and Page feature, so let's take a look at it
and how it works.
The Park and Page feature allows the caller to select a single digit option that
will place them on hold and page the subscriber that there is a caller holding.
The main setting for this feature are found in the EClass block. That means if we
want to enable this feature for only a select subscriber or group of subscribers
we will need to create a new EClass.
Park and Page settings are located on the EClass' General and OverHead Page
screens. The General screen contains the configuration for System Caller
8.1.11
PROGRAMMING
PART 8 APRIL 2007