Samsung OfficeServ 7100 Technical Manual page 63

OfficeServ 7100
TECHNICAL MANUAL
MMC: 831
DESCRIPTION:
This MMC only applies to MGI-16 cards installed in the system.
NOTE: If you only have the MP10 on-board MGI ports this becomes "READ
ONLY" MMC since it has the same values as the MP10.
This MMC provides the means to configure the Internet Protocol (IP) addressing of
the OfficeServ 7100 system MGI resources and hardware. This MMC must be
utilized if there are ITP series phone(s) and/or MGI card(s) used on the system (or if
the on-board MGI ports are enabled via licenses).
NOTE: This MMC cannot be accessed unless there is an MGI-16 card installed in
the system or has MGI licenses enabled for the built-in MGI ports on the MP10.
NOTE: When changing any IP address/value, listed below, three digits must
be input for each (octet) field. Example 192.168.1.10 input must be: 192 168
001 010
PLEASE ALSO NOTE: The first 3 parameters: IP ADDRESS, GATEWAY, and
SUB MASK - changes to these parameters will not be applied until the MGI
is reset, use the reset option below to reset the MGI.
• IP ADDRESS: Specifies the IP address for the MGI card. The MGI ports built-in
to the MP10 will have the same IP address as the MP10.
• GATEWAY: Specifies the designated LAN gateway IP address used for
contacting IP devices beyond the local subnet.
• SUB MASK: Specifies the IP subnet mask. This parameter is used by the
system to calculate the range if IP devices (subnet) that are within "direct reach"
of the MGI (without having to go through the designated network IP gateway).
• IP TYPE: Defines which IP addressing relationship is used for communications
to and from the MGI card.
• PRIVATE IP ONLY – the system assumes all ITP/VOIP devices are on the
same network. Traffic involving non-IP based devices (such as analog trunks,
digital keysets, voicemail, etc.) are handled VIA the MGI card.
• PRIVATE w PUBLIC – the system knows that there is a mixture of ITP/VOIP
devices on the same network and on remote network(s), thus communicates
accordingly based upon the entries in MMC 840 (for ITP phones).
MGI PARAMETERS
PROGRAMMING
PART 2 APRIL 2007