Toshiba GR-200 Series Instruction Manual page 648

of group settings (e.g., the 'SYS_CHG' signal; which has been connected with the trigger#9
using the setting [Trigger ID9], as default; we have been discussed in Chapter
description: Group setting for protection functions
Screen information
8.2.3
Figure 8.2-5 illustrates the structure about the 'Event Recored1' group, which can be shown
the latest event#1 at the top structure (line ○
occurred for the event#1. Preceding event#2, event#3, etc. are shown below the event#1.
Similarly, the information about the 'Event Record2' and 'Event Record3' groups are displayed
on the IED screen.
†Note: For more information about the screen operation, see Chapter
Record sub-menu
Screen scroll down
Figure 8.2-5 Event information grouped in the Event record1
Setup for the event recorder
8.2.4
Consider that an additional trip-command, which is denoted with Data ID '4A1001
8400001BB7', should be sorted into the 'Event record1' group. The settings [End of E.Record-
1]=256 and [End of E.Record-2]=512 have been made as default; hence, we may select it with
the trigger#157 by setting the [Trigger ID157]= '4A1001 8400001BB7'. Set On-OFF for the
[Trigger Mode157], because the pulse-train of the trip command should be recorded along the
pick-up and drop-off times. Remember that the preferred name for the Trigger ID157 should
be set using the [Event Name157].
(→p. 860).
Event Record1
10:48 1/4
#1 2012-07-26
12:34:51.223
F.Record clear
On
#2 2012-07-25
10:56:12.021
Set group change
4
#3 2012-07-25
10:31:12.159
F.Record clear
On
#4 2012-07-23
23:56:12.159
- 629 -
→p. 578.)
). The lines ○ and ○
b c
○
a Event record1 list
○
b The latest event#1
○
c Trigger inform ation
○
d Trigger m ode inform ation
○
e Event#2
○
f Event#3
○
g Event#4
6F2T0200 (0.15)
Technical
describes how an event
d
User interface:
GRE200 (1,2)