Table of Contents
Advertisement
Ref. No.
Displays the refrigerant circuit address
Date, Time
Sets the date and time of the data you want to display.
Confirms the date and time set above and updates the screen to the latest
OK
status.
Selects the date and time of the data you want to display by moving the probe
2(-hour gauge
or gauge of 2(-hour gauge.
Displays the data that was acquired one before or after the currently displayed
,
data.
Graph X Axis
Specifies the X-axis scale of the Graph.(30 min. / 1 hour / 2 hour)
Diagram
Switch to the Detail Diagram screen.
Status List
Switch to the Detail Status List screen. (Refer to "par. (-( Detail Status List")
Check List
Switch to the Detail Check List screen. (Refer to "par. (-6 Detail Check List")
Selects the sensor which displays the data in the graph screen. The sensor
type which can be displayed differs depending on the indoor unit area or the
Line
outdoor unit area. (for outdoor unit graph area , for indoor unit schematic and
graph area)
Deletes the displayed graph or change the order. (for outdoor unit graph area)
Order
Changes the order of the displayed schematic and graph. (for indoor unit sche-
matic and graph area)
Moves only graph screen and schematic in which flag mark is highlighted (
instantaneously.
,
(Only Graph screen is moved at the outdoor unit graph area. Schematic screen
and Graph screen are moved at the same time at the indoor unit schematic
and graph area.)
Note
Time is displayed according to the time format at the regional setting in the Con-
trol panel of Windows.
70
(Blue): Updates the screen to the latest data automatically.
(Gray): Does not update the screen automatically.
Copyright© 2009-2017 Fujitsu General Limited. All rights reserved.
)
Advertisement
Table of Contents
