Table of Contents
Advertisement
3-2-6
Mismatched Unit List
When a Name Master Database file is specified at "par. 3-2-4 Name Master Database file
selection screen", the unit data of the database file and the unit data actually scanned are
collated. If there is a mismatch, that unit address is displayed. Therefore, correct the address
setting on the board of the displayed unit and then re-scan. Repeat this work until a mis-
matched unit is not displayed.
Missing units address display field
This field displays the unit addresses and unit names whose unit data is defined by
name master database, but the relevant data could not be acquired during scanning.
Unidentified units address field
This field displays the unit address and unit model (indoor unit, outdoor unit) whose ad-
dress was received during scanning, but whose unit data is not defined by name mas-
ter database file.
OK button
The scanning acquisition data is stored and the system list screen (Refer to "par. (-3
System List") is displayed. The application icon is also displayed at the task tray.
If there is a unit mismatch, return to the scanning setting screen by clicking the [Cancel]
button and repeat collation with the scanning acquired data until there are no mis-
matches. After confirming that there are not mismatches, click the [OK] button. If the
[OK] button was clicked when there is a mismatch, the unit data acquired by scanning
is displayed on the system list screen unchanged.
Cancel button
The program returns to the scan setting screen.
22
Copyright© 2009-2017 Fujitsu General Limited. All rights reserved.
Advertisement
Table of Contents
