Table of Contents
Advertisement
Type
Displays the unit type.
Displays the indoor unit and outdoor unit capacity.
However, S and V series outdoor units are not displayed.
Capacity
Indoor unit capacity is displayed in [BTU/h] or [kW] units.
Outdoor unit capacity is displayed in [HP] or [ton] , [kW] units.
Displays {capacity value} when it is set at "par. (-(-1 Display".
Operation
Displays the operating status.
Displays the operating mode.
Mode
operation.
When "(Auto)" is displayed, operation is linked to the "Auto" mode of the master
indoor unit of the refrigerant circuit.
Set Temp.
Displays the setting temperature. (*1)
Room Temp.
Displays the room temperature. (*1)
When a unit is currently generating an error, displays [Error].
Error
The Troubleshooting screen (refer to "par. (-13-( Troubleshooting") is displayed
by clicking.
Special Opera-
Displays special operation with icon. Refer to "List of icon for special operation"
tion
below.
FAN
Displays the fan status. (*2)
Air Flow Direction
Displays vertical louver position.
V.T.
Air Flow Direction
Displays horizontal louver position.
H.Z.
Displays the R.C. Prohibition setting.
R.C. Prohibition
* Display whether the "All prohibition" is enabled or disabled.
Note
*1 Units display is [°C] or [°F]. The display format depends on the setting at the
data acquisition application. (Refer to "par. (-( Environment Setting")
*2
Sometimes, it may take time for the FAN status display to be updated in the
System List screen. The delay time is proportional to the number of exist-
ing indoor units and may take approximately 2 minutes for 100 indoor units
(the time does not have anything to do with the number of indoor units being
controlled). In any case, the actual control operation to the indoor units are
performed immediately after control operation from the Control screen, only
the display delays.
66
icon,if displayed, signifies that mode mismatch has occurred due to illegal
Copyright© 2009-2017 Fujitsu General Limited. All rights reserved.
Advertisement
Table of Contents
