Wall Mount An G-2426G-B Indoor Ont - Nokia ONT Product Manual

Install a G-2426G-B indoor ONT

Wall mount an G-2426G-B indoor ONT

Connect the fiber optic cable with SC/APC adapter to the SC/APC connector on the bottom of
the ONT.
Note: Fiber cable preparation varies depending on the type and size of the inside or
outside plant fiber cable being spliced to the SC/APC fiber optic pigtail cable.
6
Connect the power cable to the power connector.
7
Power up the ONT unit by using the power switch.
8
If used, enable the Wi-Fi service.
a. Locate the WLAN button on the ONT; see
for location of the WLAN button.
b. Press the WLAN ( Wi-Fi) button to change the status of the Wi-Fi service.
9
Verify the ONT LEDs, voltage status, and optical signal levels; see the Nokia ONT Hardware
and Cabling Installation Guide.
10
Activate and test the services; see the Nokia ONT Hardware and Cabling Installation Guide.
11
If used, configure the SLID; see the Nokia ONT Configuration, Management, and
Troubleshooting Guide.
12
If necessary, reset the ONT.
a. Locate the Reset button on a G-2426G-B indoor ONT as shown in
indoor ONT with fiber optic connector" (p.
b. Insert the end of a straightened paper clip or other narrow object into the hole in the Reset
button to reset the ONT.
E
ND OF STEPS
6.8 Wall mount an G-2426G-B indoor ONT
This chapter provides the steps to mount an G-2426G-B indoor ONT on a wall using a wall mount
bracket (3FE 49761 AA). The G-2426G-B indoor ONT is shipped without the wall mount bracket.
The wall mount bracket (3FE 49761 AA) must be ordered separately.
June 2021
Issue 1
Figure 6-1, "G-2426G-B ONT connections" (p. 71)
57).
3FE-49441-ABAA-TCZZA
Nokia ONT
Figure 5-5, "G-2426G-B
73