6.3
Commissioning of a system — Step 2: Commissioning "Smart Access Point"
6.3.1
Overview
Commissioning of the "Smart Access Point" system is carried out in 3 sections.
–
Please observe the order of the steps. They are dependent on each other.
1.
Connect the "Smart Access Point" via WLAN with a
computer and call up the website of the "Smart
Access Point".
2.
Make a preliminary decision about the system mode.
3.
Run through the wizard with selection of the system
mode.
6.3.2
Connecting a PC with the "Smart Access Point "
Attention! Loss of data
The "Smart Access Point" safely integrates the device found into the system with
the aid of certificates. This makes encrypted communication between all devices
possible.
■
Boot up the "Smart Access Point"
P E
o
Fig. 58:
Principle: Connecting the "Smart Access Point" with PC (initial connection)
System Manual
Perform a backup after commissioning.
–
If the Smart Access Point becomes defective, without a backup you
would need to re-commission the entire system.
Commissioning
see chapter 6.3.2 "Connecting a PC with the
"Smart Access Point "" on page 83
see chapter 6.3.3 "Preliminary information:
Selection of the system mode" on page 87
see chapter 6.3.4 "Commissioning the
"Smart Access Point"" on page 89
│83