Assembling The Bag And Frame - Toro 30104 Operator's Manual

2
Assembling the Bag and
Frame
Parts needed for this procedure:
1 Bag and pan
1 Catcher frame
2 Handle
4 Bolt (1/4 x 1 inch)
4 Locknut (1/4 inch)
4 Washer (1/4 inch)
Procedure
1. Slide the upper curved portion of the bagger
frame into the bag and the long straight rod
down toward the pan.
2. Snap the J-strips over the frame rods
1. Rod
3. Arrange the bag around the frame.
4. Place the handles over the slots on each side
of the frame.
(Figure
Figure 4
2. J-strip
5. Push 2 bolts (1/4 x 1 inch) through each handle
and the fabric from the outside, and secure them
with 4 washers (1/4 inch), and locknuts (1/4
inch) as shown in
1. Handle
2. Bolt (1/4 x 1 inch)
4).
g002158
6
Figure 5.
Figure 5
3. Washer (1/4 inch)
4. Locknut (1/4 inch)
g002159