Table of Contents
Advertisement
1
Assembling the Bagger
Parts needed for this procedure:
1
Back plate
1
Support
1
Mounting bracket
7
Bolt (1/4 x 5/8 inch)
7
Locknut (1/4 inch)
1
Left latch
1
Right latch
4
Phillips head screw (#10)
4
Locknut (#10)
4
Lock washer (#10)
Procedure
1.
Install the support on the back plate using 4
bolts (1/4 x 5/8 inch) and locknuts (1/4 inch) as
shown in
Figure
2.
Install the mounting bracket on the back plate
using 3 bolts (1/4 x 5/8 inch) and locknuts (1/4
inch) as shown in
1. Back plate
2. Support
3. Mounting bracket
2.
Figure
2.
Figure 2
4. Bolt (1/4 x 5/8 inch)
5. Locknut (1/4 inch)
3.
Install the latches to both sides of the back plate
using 4 phillips-head screws, lock washers, and
locknuts (#10) as shown in
Important:
nuts; the latches should be able to move up
and down.
1. Locknut (#10)
2. Right latch
3. Lock washer
g002155
5
Figure
3.
Do not completely tighten the
Figure 3
4. Phillips-head screw
5. Back plate
6. Left latch
g002156
Advertisement
Table of Contents
