Toro TX 1000 Installation Instructions Manual page 2

2
Installing the Tensioning
Decal
Parts needed for this procedure:
2 Decal
Procedure
Install the tensioning decal on a clean, dry surface on
the tension tube as shown in
of the machine.
1. Decal
Figure 1 on both sides
Figure 1
3
Removing the Tracks
No Parts Required
Procedure
Note:
Complete the procedure for both tracks.
1. Remove the locking bolt and nut
1. Tension tube
2. Locking bolt
2. Loosen the rear bolt near the drive wheel on the
track (Figure
g203951
Note:
This enables the drive wheel to pivot
forward and release the tension of the track. If
it does not pivot, turn on the engine and briefly
move the traction control forward.
1. Drive wheel
2. Track
3. Using a 1/2-inch drive ratchet, release the
drive tension by turning the tensioning screw
clockwise
2
Figure 2
3. Tensioning screw
3).
Figure 3
3. Front wheel
4. Rear bolt
(Figure 2).
(Figure 2).
g029758
g215026