Toro Reelmaster 3100-D Series Installation Instructions Manual page 5

3. Remove the 2 bolts securing the counterweight to the
left end of the cutting unit. Remove the counterweight
(Figure 5).
Figure 5
1. Counterweight
4. Using a 3/8-16 tap, remove the paint in the outer
mounting holes in the side-plate
5. Mount the roller-brush housing to the reel-bearing
housing with 2 Allen-head bolts (3/8 x 1 inch)
6). Position the roller-brush housing so that the
threaded hole is toward the front of the cutting unit.
Note: Make sure that the O-ring is properly positioned
in the roller-brush housing.
Figure 6
1. Roller-brush housing
2. Threaded hole in housing
6. Remove the 2 flange locknuts securing each roller
bracket to the side-plates
the bolts. Also, remove any 6 mm (1/4 inch) spacers
from the top side of the side-plate mounting
flange.
2. Clean out these mounting
holes.
(Figure 5).
(Figure
3. O-ring
(Figure 7). Do not remove
1. Remove the nuts securing
each end of the roller.
2. 6 mm (1/4 inch) spacer
7. Position the roller-brush mounting brackets onto the
roller-bracket bolts
1. Roller brush assembly
Important: The roller-brush mounting brackets
must be mounted directly to the top surface of the
cutting-unit side-plate mounting flange. Do not
put spacers between the roller-brush mounting
brackets and the side-plate mounting flanges.
Install additional 6 mm (1/4 inch) spacers on the
top side of the roller-brush mounting bracket
(Figure 9).
5
Figure 7
3. Side-plate mounting flange
(Figure 8).
Figure 8
2. Roller-brush mounting
bracket