Mounting The Ipc Directly On A Panel - GE PACSystems RXi Box IPC User Manual

Mounting the IPC Directly on a Panel

You will need the following:
The IPC has four captive machine screws in its base for attaching the unit to the panel.
1. Drill four mounting holes using the spacing shown in the following drawing and tap M4x0.7
Drilling Pattern for Direct Panel Mounting
2. Place the IPC on a flat surface.
3. Loosen the four captive screws on the IPC's front panel and remove the front panel.
GFK-2785C
One flathead (or large Phillips) screwdriver
One 2.5mm hex driver (included with the RXi IPC)
#29 (0.116") drill bit and M4x0.7 tap
thru.
Hardware Installation
171.7mm
(6.76")
PACSystems* RXi Box IPC
M4 Thru
95.5mm
(3.76")
19