Yamaha DTX-PRO Reference Manual page 104

Troubleshooting
Symptom
Effects cannot be
applied
The wave tempo
does not change
Pad controller does
not work
By pressing the
[REC] button, only
one song can be
recorded. The previ-
ous recording is over-
written
My training scores
are strange
Settings The DTX-PRO does
not store its settings
Data cannot be saved
on a USB flash drive
Cannot load audio
files from a USB flash
drive
Cannot load stan-
dard MIDI files from a
USB flash drive
Cannot send data to
or from the smart
device
Wave does not play
Connected external
device does not pro-
duce sound
Possible cause
• Ensure that the [EFFECT] knob is not turned down to minimum.
• Ensure that the effect type is not set to "THRU" or "NO EFFECT."
• Ensure that the InstSend value is high enough for Effect 1 or Effect
2.
Wave tempo cannot be changed. It will always play at the original
tempo of the imported file regardless of kit tempo and other settings.
Pad controllers are not supported.
Only one song can be recorded to the DTX-PRO.
Crosstalk is occurring See the section on
The DTX-PRO automatically stores its system settings whenever you
turn it off using the [
• Do not turn off the DTX-PRO by unplugging the AC adaptor. This
will prevent it from storing the system settings.
• User settings for kits, click sets, and triggers must be stored manu-
ally.
USB 1.1 compatible flash drives cannot be used on the DTX-PRO.
• Ensure that the USB flash drive has been formatted using the DTX-
PRO.
• Ensure that the USB flash drive has not been write-protected.
• Ensure that there is sufficient free space on the USB flash drive to
save the data. Check the free space from "Memory Info" in MENU/
File/.
USB 1.1 compatible flash drives cannot be used on the DTX-PRO.
• Ensure that there is sufficient free space on the DTX-PRO.
• Format the USB flash drive with the DTX-PRO.
• Ensure that the file to be read is located within the root directory of
the USB flash drive (that is, not within any folder).
Check the connection. For more information, refer to the iPhone/iPad
Connection Manual or Smart Device Connection Manual for
Android™.
The wave has been For a user voice with an audio file imported into it, the sound no lon-
deleted ger plays if the wave has been deleted.
The device is not con- • Ensure that the MIDI cable has been correctly connected.
nected properly • Ensure that the MIDI channels match. For more information on MIDI
settings, see
The MIDI channels do
• When using a USB MIDI connection, ensure that USB cables have
not match
been correctly connected.
• Pads that have been assigned a function will not play sound even
A function has been
when struck. Set the "Pad Function" in MENU/Utility/Pad to "off."
assigned to the pad
• Ensure that the "MessageType" parameter from MENU/Kit Edit/
The pad volume is low
Voice is set to "note." Sounds will not be produced if this is not set to
"note."
• Ensure that the "VelLo" parameter from MENU/Kit Edit/Voice/Mes-
sageType is not set too high. Pads will produce sound only when
struck harder than the value set here.
• Ensure that the "Minimum Level" parameter from MENU/Trigger/Pad
Type has not been set too high, as this can prevent sound from
being output.
Solution
"Crosstalk."
] (Standby/On) button.
page 31.
DTX-PRO Reference Manual 104