Table of Contents
Advertisement
Chapter 2 Convenient Features
Item
Alert Level
Alert Level
Alert Test
*1:
When Mail Alert is enabled, at least one addresses should be enabled.
*2:
Can be specified only when To:X is set to "Enable".
*3:
Up to 255 characters including alphanumeric, hyphen, underscore, period, and @ (at mark) can be used.
*4:
Up to 63 alphanumeric characters excluding +, ", ?, =, <, >, #, and ¥ can be used.
*5:
Up to 255 alphanumeric characters, hyphen, and period can be used for full domain name or IP address.
*6:
Can be specified only when SMTP Authentication is set to "Enable".
*7:
When SMTP Authentication is set to "Enable", at least one of the authentic method should be enabled.
*8:
Up to 64 alphanumeric characters excluding " " blank, ",?, =, <, >, #, and ¥, can be used.
*9:
Up to 19 alphanumeric characters excluding " " blank, ",?, =, <, >, #, and ¥, can be used.
*10: Be sure to perform Alert Test after all the parameters are configured appropriately. Alert feature may fail
depending on configuration made for network or alert receiver.
82
Description
Specify the kind of event to alert.
Error
: When "Error" is detected in each sensor type, the alert
is sent to the checked address.
Error, Warning
: When "Error" or "Warning" is detected in each sensor
type, the alert is sent to the checked address.
Error, Warning, Information
: When "Error", "Warning" or "Information" is detected in
each sensor type, the alert is sent to the checked address.
Separate Setting
: You can arbitrarily select the event and the address
(To:X) to alert in each sensor type.
Execute test by sending an alert by mail.
Express5800/E120d-M Maintenance Guide
Default Value
Error, Warning
*10
－
2. BMC Configuration
Advertisement
Table of Contents
