NEC N8100-1909F Maintenance Manual page 110

Chapter 3 Appendix
Error Message
B272 PCI Slot 2 - PCIe Link Speed
Error
C000 The error occurred during
fan sensor reading.
C010 The error occurred during
temperature sensor reading
C011 System Temperature out of
the range.
C020 The error occurred during
voltage sensor reading.
C021 System Voltage out of the
range.
C040 SROM data read error
C041 SROM data checksum bad
C061 1st SMBus device Error
detected.
C062 2nd SMBus device Error
detected.
C063 3rd SMBus device Error
detected.
C064 4th SMBus device Error
detected.
C065 5th SMBus device Error
detected.
C066 6th SMBus device Error
detected.
C067 7th SMBus device Error
detected.
C068 8th SMBus device Error
detected.
C101 BMC Memory Test
Failed..
C102 BMC Firmware Code
Area CRC check
Failed.
C103 BMC core hardware failure.
BMC IBF or OBF check failed. An error was detected while
C104
C105 BMC SEL area full.
110
Cause
PCIe bus speed error was detected
on PCI slot 2.
An error was detected while reading
fan sensor.
An error was detected while reading
temperature sensor.
A temperature abnormality was
detected.
An error was detected while reading
voltage sensor.
A system voltage abnormality was
detected.
An error was detected while reading
FRU data.
A checksum error was detected
while reading FRU data.
An error was detected on 1st SM
Bus.
An error was detected on 2nd SM
Bus.
An error was detected on 3rd SM
Bus.
An error was detected on 4th SM
Bus.
An error was detected on 5th SM
Bus.
An error was detected on 6th SM
Bus.
An error was detected on 7th SM
Bus.
An error was detected on 8th SM
Bus.
An error was detected on BMC.
accessing BMC.
There is not enough space to store
the system event log.
Express5800/E120d-M Maintenance Guide
1. POST Error Message
Solution
Contact your sales representative.
It is possible that an ambient temperature of
installation site is high, or a fan has failed or
is clogged. Contact your sales
representative.
Contact your sales representative.
Unplug the power cord, wait for at least 30
seconds, then restart the server. If the same
error is detected repeatedly, contact your
sales representative.
Start up Offline Tools (Chapter 1, 7. Offline
Tools) and delete the event logs.