Odi Driver With Dos Shell - HP Vectra VL6 7 Administrator's Manual

6 The Novell INSTALL program will display a window with the settings for the card.
7 The installation of the DOS ODI driver and NetWare client software is complete.
NOTE The ODI driver default frame type is ETHERNET_802.2. NetWare 286 and 386
servers use frame type ETHERNET_802.3 as their default, but NetWare 4.0 uses
both ETHERNET_802.2 and ETHERNET_802.3 types. The HP Ethernet Family
Adapter supports both Ethernet frame types.

ODI Driver with DOS Shell

To install the ODI driver for DOS, follow the instructions below:
1 To begin the installation you require the Novell DOS Shell installation diskette
2 Create a directory on the DOS boot drive (for example C) for the HP and NetWare
The following parameters will be shown:
Optional Bus Identifier
Optional Media Frame Type(s)
Optional Node Address
Optional Media Type
Optional LAN activity LED
Press without selecting to override any parameters and proceed with the
remainder of the steps in the NetWare DOS Requester INSTALL program.
Refer to page 25 for information on how to start a NetWare client.
labeled 'WSGEN' and the LAN Disk.
files using the following commands at the DOS prompt:
C:
MKDIR C:\NOVELL
2 Installing Novell NetWare Drivers
ODI DOS Client Driver
English 23