Removing The Psu From The Chassis; Installing/Removing The Dummy Blade; Installing The Dummy Blade In The Chassis - Fujitsu PRIMEHPC FX1000 Operating Manual

Chapter 3 Starting Up
3.11 Installing/Removing the Dummy Blade
Remarks
- The PSU must be installed with the lock facing right when viewed from the back.
- Push the device until it is locked.
At any location where no PSU will be mounted, a dummy PSU must be installed.
For details on how to install a dummy PSU, see
3.10.2

Removing the PSU From the Chassis

This section describes how to remove the PSU.
1. Lift up the handle on the PSU halfway in the direction of the arrow (1), and push the latch (2).
While pushing the latch, pull out the PSU (3).
(1)
3.11

Installing/Removing the Dummy Blade

3.11.1

Installing the Dummy Blade in the Chassis

This section describes how to install the dummy blade in the chassis.
1.
Push the dummy blade into the chassis until it is locked (1).
Figure 3.22 Removing the PSU
(2)
(3)
43
"3.12.1 Installing the Dummy PSU in the Chassis."
C120-0089-03EN