Fig. 7: Removing The Foot Mounting - ABB A170-M62 Operation Manual

Operation Manual / 4 Product description / A100-M axial
2 Removal and installation / 2.2 Removing the turbocharger
Turbocharger with clamping nuts
Fig. 7: Removing the foot mounting
1. Treat the threads of the threaded rods with penetrating oil and allow it to work in.
Do not oil the pressure screws of the clamping nut.
2. Loosen the clamping nuts at the compressor-end and turbine-end foot (see
lösen →11).
3. Fit transport screws (90334 / 90335) to secure the sliding block (68003) on the left and
right on the turbine-end foot.
Lift the turbocharger from the engine and put it down.
u
Cover all oil connections.
u
© Copyright 2019 ABB. All rights reserved. HZTL4033_EN
Spannmutter
Rev.D December 2019