Operation; Applications; Fueling And Refueling The Trimmer; Oxygenated Fuels - Toro 51957 Operator's Manual

Operation

WARNING:
Do not allow familiarity with this product to
make you careless. Remember that a careless
fraction of a second is sufficient to inflict
serious injury.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1, along with
hearing protection. Failure to do so could result
in objects being thrown into your eyes and other
possible serious injuries.
WARNING:
Never use blades, flailing devices, wire, or rope
on this product. Do not use any attachments or
accessories not recommended by the manufac-
turer of this tool. The use of attachments or ac-
cessories not recommended can result in serious
personal injury.
WARNING:
Operation of this equipment can create sparks
that can start fires around dry vegetation. A spark
arrestor may be required. The operator should
contact local fire agencies for laws or regulations
relating to fire prevention requirements.

Applications

Use this product for the following applications:
■
Cutting grass, weeds, and light undergrowth
■
Edging along sidewalks and driveways

Fueling and Refueling the Trimmer

WARNING:
Gasoline and its vapors are highly flammable
and explosive. To prevent serious personal
injury and property damage, handle it with care.
Keep away from ignition sources and open
flames, handle outdoors only, do not smoke and
wipe up spills immediately.
Fuel Mixture
This product is powered by a 2-cycle engine and requires
pre-mixing gasoline and 2-cycle lubricant. Pre-mix unleaded
gasoline and 2-cycle engine lubricant in a clean container
approved for gasoline. DO NOT mix quantities larger than
usable in a 30-day period.
14
Recommended fuel: This engine is certified to operate on
unleaded gasoline intended for automotive use.
Note: We recommend you use high-quality synthetic
2-cycle lubricant in this product. Mix at 2.6 oz. per gallon
(US).
Do not use automotive lubricant or 2-cycle outboard
lubricant.
HIGH qUALITY 2-CYCLE ENGINE LUBRICANT
GasolInE
1.0 gal. (US) (3.8 liter)
2.5 gal. (US) (9.5 liter)
Filling Tank
1. Clean surface around fuel cap to prevent contamination.
2. Loosen fuel cap slowly by turning counterclockwise. Rest
the cap on a clean surface.
3. Carefully pour fuel into the tank. Avoid spillage.
4. Prior to replacing the fuel cap, clean and inspect the gasket.
5. Immediately replace fuel cap and hand tighten by turning
clockwise. Wipe up any fuel spillage.
6. Move at least 30 ft. (9 m) away from refueling area before
starting the product.
Note: It is normal for smoke to be emitted from a new
engine after first use.
WARNING:
Always shut off engine before fueling. Never
add fuel to a machine with a running or hot
engine. Move at least 30 ft. (9 m) from refueling
site before starting engine. Do not smoke and
stay away from open flames and sparks. Fail-
ure to safely handle fuel could result in serious
personal injury.

Oxygenated Fuels

NOTICE:
Do not use E15, E20 or E85 fuel (or fuel
containing greater than 10% ethanol) in this
product. It is a violation of federal law and
will damage the unit and void your warranty.
Fuel system damage or performance problems resulting
from the use of an oxygenated fuel containing more than
the percentage of oxygenates stated below are not covered
under warranty.
Ethanol. Gasoline containing up to 10% ethanol by volume
(commonly referred to as E10) is acceptable. E15 and E85
are not.
lubrIcant
2.6 oz. (76 ml)
6.4 oz. (189 ml)
Operation