JVC MPEG-2 Instruction Manual page 33

[Restore Factory Settings]
Command : InitParameters
Argument : Nil
Operation : Restore all parameters to their factory settings. To restart upon executing this command, type 'reboot'.
About 20 seconds are required for reboot. Upon reset, IP address of DM-NE300E becomes 10.0.0.1.
(3) Information Display Commands
[Status Display]
Command : Status
Argument : Nil
Operation : Displays status information.
[List of Decoders]
Command : JoiningMember
Argument : Nil
Operation : Displays list of IP addresses of decoders currently receiving data.
[Error Log Display]
Command : ErrorLog
Argument : Nil
Operation : Displays error log.
[List of Commands]
Command : Help
Argument : Nil
Operation : Displays list of commands in alphabetical order.
(4) Stream Control Command
[Start Transmission]
Command : Play
Argument : Nil
Operation : Starts manual stream transmission from DM-NE300E. When in the Unicast mode, data is transmitted
to the destination address specified in ChangeDestinationAddress. When in the Multicast mode,
data is transmitted to the multicast address specified in ChangeMulticastAddress.
Use the ChangeMulticast command to switch between unicast and multicast modes.
[Stop Transmission]
Command : Stop
Argument : Nil
Operation : Stops stream transmission.
27