JVC MPEG-2 Instruction Manual page 11

Rear Panel
MAINTENANCE
RESET
#
AUDIO IN
RS232C
L
$
RS422
R
VIDEO IN
%
VIDEO SELECT
100BASE-TX
Y/C IN
^
AC IN
fi
fl
●
Set up this equipment near a power point.
●
Unplug the equipment from the power point or re-
move power cord from the AC inlet (AC IN) of this
equipment to cut off power completely.
Fasten by attaching the switch plates supplied after
* ⁄
setting items and
This shall be performed by the sales outlet at which
this equipment is purchased.
#
[RESET] Switch
Use a pointed object to depress button.
This equipment will be reset.
(
⁄
SERIAL
)
*
DV IN
&
¤
‹
›
‡
.
$
[AUDIO IN] Input Terminals
Analog audio input terminals.
Disabled when DV IN terminal is used.
%
[VIDEO IN] Terminal
Video (Composite) input terminal. Set the
SELECT] Switch at the center when using this as
the input terminal.
^
[Y/C IN] Terminal
Video (Y/C) input terminal. Set the
LECT] Switch at the lower end when using this as
the input terminal.
&
[DV IN] Terminal
DV input terminal. Set the
Switch at the upper end when using this as the input
terminal.
*
[VIDEO SELECT] Switch
To select either DV, Composite or Y/C as video in-
put. Set to [DV IN], [VIDEO IN] or [Y/C IN] accord-
ingly depending on the signal to be used.
Turn 'OFF' the power of this equipment when oper-
ating this switch.
(
[MAINTENANCE] Switch
This terminal is used only for servicing purposes.
)
[SERIAL]
Serial terminal for controlling external device.
⁄
[RS232C/RS422] Selector Switch
This switch sets the signal format of
either RS232C or RS422.
Turn 'OFF' the power of this equipment when oper-
ating this switch.
¤
[LINK] LED
Lights up when this equipment is connected to a
network.
‹
[100BASE-TX] Terminal
100BASE-TX terminal. Output terminal for MPEG-2
stream.
›
[RXD] LED
Lights up when this equipment receives packet via
100BASE-TX.
fi
AC IN
AC 220 V~240 V inlet. Ensure to use the power cord
supplied for connection.
Make sure to earth the equipment. Do so before in-
serting the plug to the power source. When remov-
ing the earth, do so after unplugging from the power
source.
fl
Fastener
Plug in the supplied power cable, and fasten using
the fastener.
‡
Vent Outlet
*
[VIDEO
*
[VIDEO SE-
*
[VIDEO SELECT]
)
[SERIAL] to
5