Mitsubishi Electric MELSEC Q Series User Manual page 53

(2) Procedures
The procedures are as illustrated below.
(a) Processing cable end
1) Correctly place the end of the
dedicated flat cable in the cover.
(Check that the position of the orange
part is correct.)
Note 1) This orientation is incorrect.
(b) Processing for T-branch connection
5) Cut the cover edge at the two roots
using a nipper and remove the edge.
Downloaded from ManualsNet.com
2) Close the cover so that the flat cable
Orange
Note 2) If the orange part is visible
Orange
6) Attach the cover to the part from
Cut
search engine
may be held between both sides of
the cover.
Orange
through the notch window on the
front cover, open the cover and
correct the wiring.
Orange
where T-branch connection is to be
built.
Orange
CHAPTER 4 PROCEDURE BEFORE OPERATION
3) Assemble the cover with the body and
press them using pliers.
4) Check that all of four latches are
engaged. Press-fitting is completed.
7) Follow the steps 3) and 4) shown
above.
Orange
4
Orange
Orange
51