Mitsubishi Electric MELSECQ Series User Manual page 114

8
TROUBLESHOOTING
Item
PLS 4-1 Pulse input mode (CH4 to 1)
PLS 6-5 Pulse input mode (CH6 and 5)
NOP1 -
CNT
Counting speed setting
SPD
RNG
Counter format
LIN
PRSNT
Present value selection setting
VAL
NOP2 -
8
- 2
Downloaded from ManualsNet.com
(3) Checking Module's Detailed Information
Check the status of LEDs and intelligent function module switch setting, and module
information in [H/W status] on the [Module's Detailed Information] screen which can
be displayed from [System Monitor] of GX Developer Version 7.17T or later.
[Setting procedure]
Select [Diagnostics]
Information...]
Figure 8.2 [H/W Information] screen
[H/W LED Information]
The following information is displayed on the [H/W LED Information] screen.
Item
RUN "RUN" LED on the QD63P6
ERR. "ERR." LED on the QD63P6
[H/W SW Information]
The setting status of the intelligent function module switches is displayed.
Signal
8.1 Error Processing and Recovery Methods
8.1.1 Checking error description using System Monitor of GX Developer
search engine
[System monitor...]
.
Table 8.1 H/W LED Information
Signal
Table 8.2 H/W SW Information
Corresponding switch
Switch 1
Lower 8 bits
Switch 2
Upper 8 bits
Switch 3
Lower 8 bits
Switch 4
Upper 8 bits
Switch 5
[QD63P6] [Module's Detailed
Value
0: The LED is OFF.
1: The LED is ON.
Value
For details, refer to "Section 4.5
Intelligent Function Module Switch
Setting".