Touchpad - HP Elite x360 1040 G9 Maintenance And Service Manual

3. Detach the touchpad cable (3) from the top cover/keyboard. (The touchpad cable is attached to the top
cover/keyboard with double-sided adhesive.)
Reverse this procedure to install the touchpad cable.

Touchpad

To remove the touchpad, use this procedure and illustration.
NOTE: The touchpad spare part kit includes touchpad.
Table 5-16 Touchpad description and part number
Description
Touchpad
NOTE: The touchpad spare part kit does not include the touchpad cable. The touchpad cable is included in the Cable Kit, spare part
number N09289-001.
Before removing the touchpad, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the touchpad cable (see
Remove the touchpad:
1. Release the ZIF connector (1) to which the NFC module antenna cable is connected, and then disconnect the
NFC module antenna cable from the NFC module.
2. Detach the NFC module antenna cable (2) from the top cover/keyboard. (The NFC module antenna cable is
attached to the top cover/keyboard with double-sided adhesive.)
68 Chapter 5 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page
Battery on page 43).
Touchpad cable on page
41).
67).
Spare part number
N13694-001
41).