Touchpad Cable - HP Elite x360 1040 G9 Maintenance And Service Manual

2. Detach the NFC module (2) from the top cover/keyboard. (The NFC module is attached to the top cover/
keyboard with double-sided adhesive.)
3. Remove the NFC module.
Reverse this procedure to install the NFC module.

Touchpad cable

To remove the touchpad cable, use this procedure and illustration.
NOTE: The touchpad cable is included in the Cable Kit, spare part number N09289-001.
Before removing the touchpad cable, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
Remove the touchpad cable:
1. Release the ZIF connector (1) to which the touchpad cable is connected, and then disconnect the touchpad
cable from the system board.
2. Release the ZIF connector (2) to which the touchpad cable is connected, and then disconnect the touchpad
cable from the touchpad.
Preparation for disassembly on page
Bottom cover on page
Battery on page 43).
41).
41).
Touchpad cable 67