Operator control (hardware)
3.3 Error and status displays
3.3
Error and status displays
Arrangement of LED displays
The LED displays are located next to the CompactFlash card plug-in slot on the
SIMOTION D410-2.
Figure 3-7
Meaning of the LED displays
This table describes the LEDs and their meaning.
Table 3-4
D410-2 DP
RDY
RUN/STOP
OUT>5V
–
SF/BF:
Additional information
You can perform a detailed diagnosis with a PG/PC and the engineering system. For information
about diagnostics using LED displays, refer to the SIMOTION D410-2 Commissioning and
Hardware Installation Manual, Section "Diagnostics using LED displays".
46
LED displays: D410-2 DP (on the left), D410-2 DP/PN (on the right)
Error and status displays
LED
D410-2 DP/PN
RDY
RUN/STOP
–
OUT>5V/SY
SF/BF:
Meaning
Status indicator of the SINAMICS Integrated
SIMOTION D410-2 operating states
Encoder current supply > 5 V (TTL/HTL)
Encoder current supply > 5 V (TTL/HTL)
Synchronization status (SY) of the onboard PROFINET IO inter‐
face (X150)
Group error / bus fault
Equipment Manual, 07/2021, A5E33446720B
SIMOTION D410-2