Troubleshooting - Sanyo PLV-HD2000E Owner's Manual

APPENDIX
Before calling your dealer or service center for assistance, check matters below once again.
1. Make sure you have connected a projector to your computer or video equipment as described in section "CONNECTING
PROJECTOR" on pages 13 ~ 16.
2. Check cable connection. Verify that all computer, video and power cord are properly connected.
3. Verify that all power is switched on.
4. If a projector still does not produce an image, re-start your computer.
5. If an image still does not appear, unplug a projector from your computer and check your computer monitor's
display.Problem may be with your graphics controller rather than with a projector. (When you reconnect a projector, be
sure to turn a computer and monitor off before you power up a projector. Power equipment back on in order of : Projector
and computer.)
6. If problem still exists, check following chart.
Problem:
No power.
Image is out of
focus.
Picture is Left/Right
reversed.
Picture is
Top/Bottom
reversed.
Some displays are
not seen during
operation.
No image.
Remote Control Unit
does not work.
46

TROUBLESHOOTING

G Plug a projector into your AC outlet.
G Turn MAIN ON/OFF switch to ON.
G Press POWER ON/OFF switch to ON.
G Make sure READY Indicator lights.
G Wait 90 seconds after a projector is turned OFF when turning a projector back on.
NOTE : After pressing Power ON-OFF button to OFF, make sure a projector works as
follows:
1. LAMP indicator lights bright and READY indicator turns off.
2. After 90 seconds, READY indicator lights green again and a projector may be
turned on by pressing Power ON-OFF button.
G Check WARNING TEMP. and READY indicator. If both WARNING TEMP. and READY
indicator flashes, a projector cannot be turned on.
(See "TURNING ON/OFF PROJECTOR" section on page 23.)
G Check Projection Lamp. (Refer to page 44.)
G Adjust focus of a projector.
G Check Projection Lens to see if it needs cleaning.
NOTE : Moving a projector from a cool temperature location to a warm temperature location
may result in moisture condensation on Projection Lens. In such an event, leave a
projector OFF and wait until condensation disappears.
G Check Ceiling / Rear feature. (See "SETTING" section on page 39.)
G Check Ceiling feature. (See "SETTING" section on page 39.)
G Check Display feature.(See "SETTING" section on page 38.)
G Check connection between your computer or video equipment and a projector.
G When turning a projector on, it takes about 20 seconds to display an image.
G Check system that you select is corresponding with your computer or video equipment.
G Make sure temperature is not out of Operating Temperature (5°C ~ 30°C).
G Check batteries.
G Make sure nothing is between Infrared Remote Receiver and Remote Control Unit.
G Make sure you are not too far from a projector when using Remote Control Unit.
Maximum operating range is 16.4' (5m).
G Check remote control code from Remote Control Unit.
(See "SETTING" section on page 40.)
Try these Solutions