Picture Level And Tilt Adjustment; Installing Projector In Proper Position - Sanyo PLV-HD2000E Owner's Manual

PREPARATION
Picture tilt and projection angle can be adjusted with
handles on both sides of a projector. Projection angle
can be adjusted to 5.7 degrees upper way.
Press knob on handle. Handle pop out.
1
2 Turn handles (right and left) until picture is projected on
proper position. Adjust height of rear adjustable feet by
rotating them until projector properly stabled on table.
3
Press knob and retract handle.
Install the projector properly. Improper installation may reduce the lamp lifetime and cause a fire hazard.
10˚
10˚
NO UPWARD
NO DOWNWARD
NO SIDEWAYS
10

PICTURE LEVEL AND TILT ADJUSTMENT

INSTALLING PROJECTOR IN PROPER POSITION

Do not tilt the projector more than 10 degrees above and below.
Do not point the projector up to project an image.
Do not point the projector down to project an image.
Do not put the projector on either side to project an image.
REAR ADJUSTABLE
FEET. (Refer to P7).
LEVEL AND TILT
ADJUST HANDLE
ADJUSTABLE
FEET
Height of front feet can be adjusted
by turning handles.
KNOB