Sanyo PLV-HD2000E Owner's Manual page 35

Noise reduction
Press POINT LEFT/RIGHT button(s) to change noise reduction
mode. Dialog box display is changed to "Off", "L1", "L2" or "L3" to
reduce noise (rough parts) of image.
Off ······· Noise reduction OFF position.
L1 ········ Noise reduction LEVEL 1 position.
L2 ········ Noise reduction LEVEL 2 position.
L3 ········ Noise reduction LEVEL 3 position.
Progressive
Press POINT LEFT/RIGHT button(s) to change progressive scan
mode. Dialog box display is changed to "Off" and progressive scan
mode to off. Press POINT LEFT/RIGHT button(s) again, progressive
scan mode to on.
Auto picture control
Press either POINT LEFT button or POINT RIGHT button to Auto
picture control position that you want to select . (Off, L1 or L2)
Off ······· Auto picture control OFF position.
L1 ········ Auto picture control LEVEL 1 position.
L2 ········ Auto picture control LEVEL 2 position.
Auto lamp control
The projector reduce the brightness and set into the low power
consumption mode. When this function is "On", the brightness is
adjusted automatically to a level that is suitable for the screen.
Color Management
The Color management function can be used to adjust the level and
phase of the selected display colors on the screen, and to replace
these colors with other colors if required.
The projector lets you replace up to thirty-two colors for each image.
1 Press the POINT UP/DOWN button to move the red frame point-
er to "COLOR MANAGEMENT", and then press the SELECT
button. The COLOR MANAGEMENT menu will appear and
pointer mode will be enabled. The image that was being project-
ed when the button was pressed will be paused, and the COLOR
MANAGEMENT POINTER will appear.
Use the POINT buttons to move the pointer to a section of the
2
paused image that contains the color that you would like to
adjust, and then press the SELECT button. The mode will
change to COLOR SELECTION mode, and the color in the cen-
ter of the pointer will be selected and adjustment will be possi-
ble.
3 Use the POINT buttons to adjust the level and phase of the
color, and then press the SELECT button to confirm the setting.
When the SELECT button is pressed, the mode will change to
LIST mode.
DISPLAY ADJUST
Press SELECT button at this icon
to display previous items.
Press POINT LEFT/RIGHT buttons
to change position.
Press SELECT button at this icon
to display first items.
POINTER MODE
COLOR
MANAGEMENT
POINTER
35