Sanyo PLV-HD2000E Owner's Manual page 14

CONNECTING PROJECTOR
SERIAL PORT
IN TERMINAL
If you control a projector by computer,
you must connect a cable (not supplied)
from your computer to this terminal.
SERIAL PORT
OUT TERMINAL
This terminal outputs signal
from SERIAL PORT IN. More
than two projectors can be
controlled with one computer
by connecting SERIAL PORT
IN. of another projector to this
terminal.
R/C JACK
When using Wired / Wireless Remote
Control Unit as Wired Remote
Control, Connect Wired Remote
Control Unit to this jack with Remote
Control Cable (not supplied).
(Refer to page 19.)
14
SERIAL PORT IN
SERIAL PORT OUT
R/Pr
R/C JACK USB
AUDIO OUT
R L
RESET
(MONO)
This projector uses a micro processor to control unit.
Occasionally, micro processor may malfunction and
need to be reset. This can be done by pressing
RESET button with a pen, which will shut down and
restart unit. Do not use RESET function excessively.
AUDIO OUTPUT JACKS
Connect an external audio
amplifier to these jacks.
(Refer to P15, 16.)
USB PORT (Series B)
This port is used to service this
projector.
Connect USB port of computer to this
port.
IN LINK A OUT
IN
G/Y B/Pb H/HV V
R
DVI
R
RESET BUTTON
LINK B OUT
AUDIO CONTROL PORT
L
(MONO)
AUDIO CONTROL PORT
L
(MONO)