Controlling The Time-Lapse Vcr With A Ps·data System Controller - Panasonic WJ-SX 150A Operating Instructions Manual

TIME-LAPSE VCR CONTROL
A time-lapse VCR is operable with the system controller,
while connecting to the matrix switcher.
Notes:
• The same descriptions as the system controller's
operating instructions are not mentioned here. Refer
to them.
• Before the use, it is necessary to install the
Multiplexer board in the matrix switcher, connect
the matrix switcher to the digital disk recorder, and
configure
Administrator Console, OSD SETUP MENU, and
time-lapse VCR's SETUP MENU. [Refer to p. 32
Installing the Multiplexer Board, p. 47 Connection
with the Time-lapse VCR (Non-Panasonic Models),
p. 63 WJ-SX150A SETUP MENU (OSD), and p. 79
WJ-SX150A ADMINISTRATOR CONSOLE.]
• You cannot control non-Panasonic time-lapse VCRs
from PS·Data system controllers.
The following is the procedure of a non-Panasonic model
time-lapse VCR.
Controlling the Time-lapse VCR
with a PS·Data System
Controller
Manual Recording
Refer to the time-lapse VCR's operating instructions for how
to operate.
Normal Playback
1. Enter the recorder mode. (Refer to p. 141.)
2. Do the playback procedure using the buttons on the
front panel of time-lapse VCR. (Refer to the time-lapse
VCR's operating instructions for how to operate.)
3. Press the VCR/CAM button. The playback image will
appear on the monitor.
4. To display the spot picture, press the numeric buttons
corresponding to the desired camera number, then
press the CAM [SET] button. Then, the active monitor
number with "-H**" (** is logical the camera number)"
will appear on the LED display. (Refer to p. 132 Normal
Playback for the illustration.)
146
the system through
[NON-PANASONIC MODELS] (PS·DATA)
MUX
Other Operations
Refer to the time-lapse VCR's operating instructions for how
to operate.
WJ-SX150A