Appendix A Specifications - NEC Express5800 Series User Manual

Appendix A
Specifications
Item
Memory capacity
Data transfer rate (tape)
LTO Interface
Mezzanine card slot Type I
LAN interface
External dimensions (mm)
Weight
Power supply
Power consumption (+12Vdc)
Environmental
requirements
Use condition of data
cartridge
Storage condition of
data cartridge
Type II
Temperature
Humidity
Temperature
Humidity
Exposure time
Temperature
Humidity
Exposure time
Tape Blade AT101b
N8404-005F
1.5 Tbyte (uncompressed, using LTO5 cartridge)
See "Available Data Cartridge" in Chapter 1.
140 Mbyte/sec (uncompressed, using LTO5
cartridge)
Above is the specification for the drive itself. Actual
data transfer rate depends on the server to which
the Tape Blade is connected. Therefore, the
specified transfer rate may not be achieved. It is
recommended that the actual backup time is
measured before the system is formally used since
the actual required backup time depends on the
total system environment.
SAS (6 Gbps)
2 max. (when Mezzanine Card Type II is not used)
1
1000Base-T × 2 channels
181 (H) × 516 (D) × 52 (W)
5.0 kg Max.
+12Vdc (supplied from the power supply unit
installed in Blade Enclosure)
120 W
10 to 35°C
20 to 80% RH (no dew condensation allowed)
10 to 45ºC (gradient: 10ºC/hour)
10 to 80% (Wet bulb: 26ºC max.)
Adapt the data cartridge to operating environment
for longer than it had been left in an environment
beyond the operating and/or storage condition (8
hours max.) before using the cartridge.
16 to 32ºC (gradient: 10ºC/hour)
20 to 80% (Wet bulb: 26ºC max.)
Put the cartridge in protective case, and put a lid on
the case. You can store it vertically or horizontally.