Close the operating PC ....... . . 3 - 3 4 _______Changes to previous version _____________________________________ 4 - 1 Siemens AG Register 5 RXL2-120.091.08 Page 3 of 4 LITHOSTAR Multiline Medical Engineering Rev. 04 10.00 TD PS 24 System Manual...
Page 4
0 - 4 Contents Page This page intentionally left blank. LITHOSTAR Multiline Register 5 RXL2-120.091.08 Page 4 of 4 Siemens AG System Manual Rev. 04 10.00 TD PS 24 Medical Engineering...
6 Monitor port X51 DUEP port 3 Serial interface COM 1 7 Power line connector 4 Monitor power line connector Siemens AG Register 5 RXL2-120.091.08 Page 1 of 4 LITHOSTAR Multiline Medical Engineering Rev. 04 10.00 TD PS 24 System Manual...
Page 6
Press any key, to continue Eine beliebige Taste drücken, um fortzusetzen. • I f the keyboard is replaced, the User Terminal software must be reinstalled. Answer accordingly. LITHOSTAR Multiline Register 5 RXL2-120.091.08 Page 2 of 4 Siemens AG System Manual Rev.
Page 7
Eine beliebige Taste drücken, um fortzusetzen • Remove backup disk 05 from drive A. • Insert the User Interface SW disk in drive A. Siemens AG Register 5 RXL2-120.091.08 Page 3 of 4 LITHOSTAR Multiline Medical Engineering Rev. 04 10.00 TD PS 24 System Manual...
Page 8
Switch the system OFF. • Remove the boot disk from drive A. • For the additional steps required, refer to the chapter which corresponds to the operating PC being used. LITHOSTAR Multiline Register 5 RXL2-120.091.08 Page 4 of 4 Siemens AG System Manual Rev.
Enter the password "TDRX". • Press the "ENTER" key twice; use "Entrée" on the French keyboard. • Enter the password "TDRX" again. Siemens AG Register 5 RXL2-120.091.08 Page 1 of 4 LITHOSTAR Multiline Medical Engineering Rev. 04 10.00 TD PS 24 System Manual...
• For the upper part of the housing - slightly lift the rear edge (1/Fig. 2). - slide towards the front (2/Fig. 2). - lift it upwards (3/Fig. 2). LITHOSTAR Multiline Register 5 RXL2-120.091.08 Page 2 of 4 Siemens AG System Manual Rev.
Pro C6: Plug the wire marked with "D51 X3" at X3 on the board D5. • Reconnect all cables except the DUEP X51 at PC. • Switch the system OFF. Siemens AG Register 5 RXL2-120.091.08 Page 3 of 4 LITHOSTAR Multiline Medical Engineering Rev. 04 10.00 TD PS 24 System Manual...
Push in the drawer; be careful of the cable layout in the operating console. • Push the operating PC to the back and right in the operating console, so that the ventila- tion ducts are not blocked. LITHOSTAR Multiline Register 5 RXL2-120.091.08 Page 4 of 4...
Page 13
Drill 2 holes (4.2 mm dia.) each 15 mm from the upper edge on both sides of the PC drawer (1/Fig. 2). Siemens AG Register 5 RXL2-120.091.08 Page 1 of 4 LITHOSTAR Multiline Medical Engineering Rev. 04 10.00 TD PS 24 System Manual...
Page 14
Press the "ENTER" or "Entrée" key twice. • After a short time the Multiline operating software startup message appears: No Host Communication. • System OFF. LITHOSTAR Multiline Register 5 RXL2-120.091.08 Page 2 of 4 Siemens AG System Manual Rev. 04 10.00...
Fasten the control unit to the drawer. • Push in the drawer paying attention to the cable run in the console. Siemens AG Register 5 RXL2-120.091.08 Page 3 of 4 LITHOSTAR Multiline Medical Engineering Rev. 04 10.00 TD PS 24 System Manual...
Page 16
3 - 4 Operating PC LM Control Unit This page intentionally left blank. LITHOSTAR Multiline Register 5 RXL2-120.091.08 Page 4 of 4 Siemens AG System Manual Rev. 04 10.00 TD PS 24 Medical Engineering...
Page 17
4 - 1 Chap. 0 Cover page, contents and Rev. status newly created Chap. 1 - Chap. 3 Completely revised Siemens AG Register 5 RXL2-120.091.08 Page 1 of 2 LITHOSTAR Multiline Medical Engineering Rev. 04 10.00 TD PS 24 System Manual...
Page 18
4 - 2 Changes to previous version This page intentionally left blank. LITHOSTAR Multiline Register 5 RXL2-120.091.08 Page 2 of 2 Siemens AG System Manual Rev. 04 10.00 TD PS 24 Medical Engineering...