Table of Contents
Advertisement
September 2004
KV Input Selection
Number of Traverses and
Transducer Spacing
2-10
]
1. Press [
and [ ] to enter a static kinematic viscosity or a table of
values and press [ENTER] .
2. Do one of the following:
•
If you selected Table , enter the Calibration Factor by using the
arrow keys. Press [
desired location and press
the number. Then press [ENTER] .
•
If you selected STATC , the AT868 will select and automatically
display the Kinematic Viscosity (see note below). If you want
to enter a different number use the [
cursor to the desired location and press
increase or decrease the number. Then press [ENTER] . Enter the
Calibration Factor in a similar manner and press [ENTER] .
Note: If you select OTHER as the fluid type, you must enter the
Kinematic Viscosity. The AT868 will only approximate the
Kinematic Viscosity if you select one of the specific available
fluid options.
3. Proceed to one of the following sections:
•
Clamp-on Transducers - proceed to Number of Traverses and
Transducer Spacing below.
•
Wetted Transducers - The meter returns to the Channel
PROGRAM window. To complete initial setup of the AT868, you
must enter data in the GLOBL-SYSTM submenu on page 2-12.
]
1. Press [
and [ ] to select the number of traverses and press
[ENTER] .
2. Enter the value for the transducer spacing by using the arrow keys.
]
Press [
and [ ] to move the cursor to the desired location and
[ ] and [ ]
press
to increase or decrease the number. Then
press [ENTER] .
]
and [ ] to move the cursor to the
[ ] and [ ]
to increase or decrease
]
and [ ] to move the
[ ] and [ ]
Programming Site Data
to
Advertisement
Table of Contents
