Antenna placement
Complete antenna placement
When antenna placement is complete, click the [Antenna location complete] button.
X If an error occurs with antenna placement
If an error occurs with antenna placement, the "Reconsider the antenna location" error message appears and the area
where the error occurred is indicated by a red frame as shown in the figure below.
Cause of error
An error occurs because the antenna coverage area does is not large enough to cover the size of the area (room).
For example, if the setting of "[Mic usage side]" (page 19) for an area is [All], an error will occur if the antenna
coverage area does not extend to the four corners of the area (room).
In the case of the figure above, an error occurs because the placed antennas cannot cover to the upper side part of area
2.
Solution
Add an antenna so that the antenna coverage area is large enough to cover the entire area or revise the [Mic usage
side] setting. Also perform the procedure described in "[Change TX PWR]" (page 31) if necessary.
In the case of the figure above, you need to place four antennas at ceiling height (recommended placement) or set [Mic
usage side] to [Lower side].
33