Table of Contents
Advertisement
FCC Compliance
Part 15 notification
This device complies with part 15 of the FCC rules. Operation is subject to the following three conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation.
(3) Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment.
Note In order to maintain compliance with FCC Class B rules, shielded cable must be used (Belden 8723 or equivalent).
Part 68 notification
This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the inside of the door of the
enclosure of this equipment is a label that contains, among other information, a product identifier in the format US:AAAEQ##TXXXX. If
requested, this number must be provided to the telephone company.
The REN is used to determine the number of devices that may be connected to a telephone line. Excessive RENs on a telephone line may
result in the devices not ringing in response to an incoming call. In most but not all areas, the sum of RENs should not exceed five (5.0).
To be certain of the number of devices that may be connected to a line, as determined by the total RENs, contact the local telephone
company. For products approved after July 23, 2001, the REN for this product is part of the product identifier that has the format
US:AAAEQ##TXXXX. the digits represented by ## are the REN without a decimal point (e.g., 03 is a REN of 0.3). For earlier products,
the REN is separately shown on the label.
If this equipment causes harm to the telephone network, the telephone company will notify you in advance that temporary discontinuance
of service my be required. But if advance notice isn't practical, the telephone company will notify the customer as soon as possible. Also,
you will be adviced of your right to file a complaint with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operations, or procedures that could affect the operation of the
equipment. If this happens the telephone company will provide advance notice in order for you to make necessary modifications to
maintain uninterrupted service.
If trouble is experienced with this equipment, for repair or warrenty information, please contact GE Interlogix technical support at 800
648-7424. If the equipment is causing harm to the telephone network, the telphone company may request that you disconnect the equip-
ment until the problem is solved.
This equipment must have the ability to seize the line in the event of an emergency. Do not connect this equipment to a party line service
as line seizure is not possible.
Automatic dialers
When programming emergency numbers and (or) making test call to emergency numbers:
1.
Remain on the line and briefly explain to the dispatcher the reason for the call.
2.
Perform such activities in the off-peak hours, such as early morning or late evenings.
UL Compliance Statement
UL Listings
UL 264, Standard for Access Control System Units
UL 365, Standard for Police Station Connected Burglar Alarm Units and Systems
UL 609, Standard for Local Burglar Alarm Units and Systems
UL 1610, Standard for Central-Station Burglar-Alarm Units
UL 1635, Standard for Digital Alarm Communicator System Units
To maintain compliance with UL365, UL609, and UL1610:
Mercantile Premises Alarm Systems
1.
Zone types 22, 28, 29, and 30 (Auto Reset) can not be used.
2.
Force arming is not allowed (see the Alliance System Programming Manual).
3.
Siren time should be programmed for no less than 15 minutes (see the Alliance System Programming Manual).
4.
Siren delay time must be set to 0 seconds (see the Alliance System Programming Manual).
5.
Total combined entry/exit time can not exceed 60 seconds (see the Alliance System Programming Manual).
20
AL-2017/AL-3017 Installation Manual
Advertisement
Table of Contents
