GE Alliance AL-2017 Installation Manual page 22

6. Alarm sounding device must be powered by the control unit and the siren test must be programmed "YES" (see the Alliance System
Programming Manual).
7. Safe and vault supervision circuits must be programmed for 24-hour operation (see the Alliance System Programming Manual).
8. The system must be programmed for 24-hour test reports to be sent to the control station (see the Alliance System Programming
Manual).
9. Dual zone operation is not permitted.
10. Reporting to central station 2, 3, and 4 must be set to "NO" (see the Alliance System Programming Manual).
11. Display shunted zones on LCD keypad must be set to "YES" (see the Alliance System Programming Manual).
12. Resets from RAS without code must be set to "NO" (see the Alliance System Programming Manual).
13. AC fail delay time must not exceed 240 minutes (see the Alliance System Programming Manual).
14. System tamper activates siren and strobe must be set to "YES" (see the Alliance System Programming Manual).
15. Latching system alarms must be set to "YES" (see the Alliance System Programming Manual).
16. Siren types must be set to "1" (see the Alliance System Programming Manual).
17. Enable PSTN line monitor must be set to "YES" (see the Alliance System Programming Manual).
18. Sirens only after fail to report must be set to "NO" (see the Alliance System Programming Manual).
Mercantile safe and vault
In addition to the above requirements, Mercantile Safe and Vault Alarm Systems must comply with the following:
1. Alarm sounding device output must be mechanically and electrically protected (see hook-up label).
Bank safe and vault
In addition to the above requirements, Bank Safe and Vault Alarm Systems must comply with the following:
1. This equipment must be installed within a complete vault, a complete safe, or an extent number 1 stockroom.
2. The system must be programmed to inhibit disarming the system during closed hours (see the Alliance System Programming
Manual).
Note: For Bank Safe and Vault applications, both the internal and external alarm sounding devices must be the UL Listed
Ademco, Model AB12M.
For Mercantile Premise and Mercantile Safe and Vault applications, the alarm sounding devices must be a UL Listed Burglar
Alarm bell or siren such as the Moose, Model MPI35.
Note: The maximum AUX Power output including comms bus power (max total):
AL-2017
AL-3017
AL-2017/AL-3017 Installation Manual
24-Hour 72-Hour
500mA 100mA
500mA 100mA
21