Troubleshooting; Fcc Notice - GE 45633 User Manual

A Z-Wave™ network can integrate devices of various classes, and
these devices can be made by different manufacturers. Although
every Z-Wave certified product is designed to work with all other
Z-Wave certified products, your controller must include the appro-
priate device classifications in order to control non-lighting Z-wave
devices. As an example, the GE 45600 basic remote is designed
only for controlling Z-Wave devices using the lighting control clas-
sification. The GE 45633 LCD remote can control Z-Wave certified
thermostats and door locks as well as lighting.

TROUBLESHOOTING

• If you are having difficulty adding a device to your network, try
deleting it and then adding it. Deleting it will reset the device
to its factory default settings and allow it to be added to a new
network.
• If a light/dimmer appears to be off and not responding to the
remotes ON command, try increasing the brightness level. GE
dimmers are programmed to turn on to their last used bright-
ness level. Lowering the brightness level of a GE dimmer to its
minimum setting does not turn the device off even though it
looks like it is off.
• Check the Z-Wave FAQs in the Support section of our website for
additional information: http://www.jascoproducts.com/z-wave/
GE-Z-Wave-Support.asp.
If the unit has no respond or locked up when the battery is in good
condition, disconnect one battery momentary to recover to
normal operation.

FCC NOTICE

This device complies with Part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protec-
tion against harmful interference in a residential installation.
If this equipment does cause harmful interference to radio or tele-
vision reception, which can be determined by turning the equip-
28