Tine Shield; Bolt-M8 X 20 Mm; Washer-M8; Bolt (M8 X 45 Mm) - Toro 58602 Manual

2. Install the tine shield. Align the slots on both
sides of the shield and insert the fasteners
before tightening them.
Important:
Ensure that the dirt shield is
between the engine-mount deck and tine
shield.
Figure 4
1. Bolt—M6 (4)

2. Tine shield

3. Locknut—M6 (4)
3. Install the tines to the desired position; refer to
Changing the Tilling Width (page
g356256
4. Engine mount deck
5. Dirt shield
10).
4. Install the upper handle assembly onto the lower
loop mount.
Note:
Install the bolts with the head facing
outward.
1. Bolt—M8 x 20 mm (2)
2. Washer—M8 (2)
5. Rotate the handle to the desired position and
install the upper fasteners.
Note:
Use the front hole for the highest position;
use the rear hole for the lowest position. Install
the bolts with the head facing outward as shown
in Figure 7.
1. High position
2. Middle position
3. Low position
7
Figure 5
3. Locknut—M8 (2)
Figure 6
4. Upper bolt
5. Lower bolt
6. Lower loop mount
g356424
g356255