Toro 02900 Fitting And Operation Instruction Sheet page 9

FITTING INSTRUCTIONS Continued
59. The final part to be fitted is the pressure switch that controls the
brake lights. This is screwed into the main transmission line.
60. Locate the three hose connections on the right side of the
transmission pump.
61. The lower front connection to the pump has a tee fitting with a
blanking cap.
62. Remove this blanking cap and screw on the pressure switch
adapter (item 12) using a ¼" dowty seal (item 36).
63. Screw the pressure switch (item 9) into this adapter.
Recommended tightening torque for these connections is 34Nm.
64. The electrical connector (item 35) must now be attached to the
cable on the main wiring loom.
65. Locate this cable (it will be coiled up and tied to the main loom
adjacent to the pressure switch). Connect wires to the plug. Refer
to Fig 8.
66. Plug the connector onto the pressure switch.
67. Cable tie all cables for the front lights, rear lights and the
pressure switch so that they are secure and to prevent them from
becoming trapped or chaffed.
68. Reconnect the battery positive cable.
69. Test the switches on the control panel to ensure that they are
handed correctly.
70. Refit the control panel ensuring that no connectors have become
detached and that no cables are nipped.
71. Lower and latch the engine cover.
72. Apply the reflectors to the engine cover. Ensure that the outside
edge of the reflector is adhered between 100-150mm from the
edge of the engine cover. Refer to Fig 9.
73. Lower and latch the operator platform.
74. Fix the serial label adjacent to the machine serial label.
Issued: 24.03.11 Approved:
Fig 8
+ BR
1
2 4
3
- BU
Fig 9
Mod. No. 5062856.A
G/Y
sig
Sheet 9 of 12 Part No. 111-5100 (A)