Advertisement
Quick Links
LED Light Kit
Walk-Behind Greensmaster
Mowers Equipped with Subaru EX13 or Lithium Ion Battery
Model No. 04265
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Wire harness – LED
Wire harness – Power supply (Gas models
only)
LED light with mounting hardware (1 bolt, 1
washer, 1 nut)
Flange nut
Washer
Right bar
Left bar
Switch
Bolt (5/16 x 1 inch)
Bolt (5/16 x 1–1/4 inch)
Cable tie
Installation Instructions
Parts Catalog
Note: Right and left are determined from the standard
operating position.
© 2013—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
Flex 1800/2100 and eFlex 1800/2100
Qty.
1
1
2
6
2
1
Installing the LED light kit.
1
1
2
4
5
1
1
Register at www.Toro.com.
Form No. 3369-988 Rev C
Installation Instructions
Use
Original Instructions (EN)
Printed in the USA.
All Rights Reserved
Advertisement
Related Manuals for Toro 04265
Summary of Contents for Toro 04265
- Page 1 LED Light Kit Walk-Behind Greensmaster ® Flex 1800/2100 and eFlex 1800/2100 Mowers Equipped with Subaru EX13 or Lithium Ion Battery Model No. 04265 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped.
- Page 2 1. Mount the right bar to the right side of the mower 2. Repeat the procedure for the left side, using the left using two bolts (5/16 x 1–1/4 inch) and two flange bar. nuts (Figure 1). g02341 1 Figure 1 1.
- Page 3 3. Secure the two bars together using 2 bolts (5/16 x 1 inch), 2 washers, and 2 flange nuts (Figure 1 and Figure 2). Align the bar holes for 18 or 21 inch wide mowers. G023457 Figure 3 1. On/Off switch 3.
- Page 4 C. Route the power supply wire harness down the LH side of the handle towards the rear of the engine. D. Connect the harness to the two bullet connectors coming from the engine shroud. • On battery models A. Locate the open wire harness connector on the eFlex main wire harness.