Sharp PN-L803C Service Manual page 126

1-5. CONFIRM VERSION OF FIRMWARE BY SERVICE MENU
With the image being displayed, use the remote copntroller and display SERVICE MENU1. Then, confirm the version of the firmwares.
Press the [SIZE] button of the remote control for about 5 seconds (the LED blinks, and the "F" mark is displayed in the upper left corner of
screen.), press the [BRIGHT- ( )], [VOL - ()] , [BRIGHT+ ()] and [VOL+ ()] button in sequence. Press [MENU] button on the
controller to close SERVICE MENU1 after the versions are confirmed.
SERVICE MENU1
SERVICE1
MODEL ： PNxxxxx
SERVICE2
INTEGRATED VERSION
VER (MAIN) : OK Ver 1.00
SERVICE3
VER (SUB)
VER (TPFW) : OK Ver 1.00
VER (TPCON) : OK Ver 1.00
VER (DP RX) : OK Ver 1.2.4.117
VER (DP TX) : OK Ver 1.1.4.6
VER (DSD)
VER(LCD)
USAGE TIME
ADJUSTMENT CHECK
<CAUTION>
Do not perform the firmware update and the internal controller update at the same time.
: OK Ver 1.00.10 (150101) C/S：OK
: OK Ver 8.32
: OK 2014013080435100
： W/B CALIB
PN-L803C_80TC3 FIRMWARE UPDATE PROCEDURES 5 - 3
1/1
S/N ： XXXXXXXX
： Ver 1.0.2.0
(150101) C/S：OK
C/S：OK 1234ABCD
C/S：OK 1234ABCD
C/S：OK
C/S：OK
VER(KEY) : OK Ver1.00
： 100H
1234ABCDEF
1234ABCD
1234ABCD
1234ABCD
END・・・[MENU]