Terminating Operator Maintenance Mode; Auto-Timeout Notification - Canon imagePRESS C800 Series Operator's Maintenance Manual

1
Initial Setup > Basic Operation > Login to Operator Maintenance Mode > Auto-timeout Notification

■ Terminating Operator Maintenance mode

When all operator maintenance works are completed, terminate Operator Maintenance mode.
1) Press [End] in operator maintenance basic screen.
-> Operator maintenance mode is terminated to return to Operator Maintenance
(Adjustment/Maintenance) screen.
1 Initial Setup > Basic Operation > Login to Operator Maintenance Mode > Auto-timeout Notification

■ Auto-timeout Notification

When no operation is made for certain duration in Operator Maintenance mode, the password
screen is redisplayed. This is called as auto-timeout notification.
Enter the password and press [OK] to return to Operator Maintenance mode.
The auto-timeout is not notified when performing adjustment/maintenance.
F-1-6
NOTE:
Auto-timeout conditions can be checked/changed with the following setting.
"Settings of Auto-Timeout Conditions"(page 1-39).
F-1-7
1-4
F-1-8
1-4