Advertisement
Procedure
13
14
1
Preparing the Machine
For Cutting Units Installed on the
Machine
No Parts Required
Procedure
1.
Park the machine on a level surface.
2.
Engage the parking brake.
3.
Lower the cutting units.
4.
Shut off the engine, remove the key, and wait for
all moving parts to stop.
5.
Remove the cutting units from the machine; refer
to the Operator's Manual for the traction unit.
Description
Carriage bolt (5/16 x 2-1/4 inches), Part
No. 3230-7—sold separately
Carriage bolt (5/16 x 3-1/4 inches), Part
No. 3230-13—sold separately
Carriage bolt (5/16 x 4-1/2 inches), Part
No. 3230-30—sold separately
Spacer
Flange nut (5/16 inch)
Locknut (5/16 inch), Part No.
3296-47—sold separately
Weight
Small weight (Part No.
132-0734-03—sold separately)
No parts required
Qty.
1
1
1
Install the weights (rear cutting unit with
2
groomer only, with rear grass basket).
1
2
2
6
Finish installing the Universal Groomer
–
Drive Kit.
2
Gathering the Tools
Required for Setup
Parts needed for this procedure:
–
Torque wrench (Not included)
Note:
Ensure that the torque wrenches are capable
of torquing both clockwise and counterclockwise.
•
Torque wrench—5.2 to 6.8 N∙m (46 to 60 in-lb)
•
Torque wrench—16 to 22 N∙m (12 to 16 in-lb)
•
Torque wrench—20 to 26 N∙m (15 to 19 in-lb)
•
Torque wrench—115 to 129 N∙m (85 to 95 ft-lb)
•
Torque wrench—135 to 150 N∙m (100 to 110 ft-lb)
•
Reel driveshaft tool, Part No. TOR4074
•
Long-handled pry bar (3/8 x 12 inches)
Service Tools
Oil syringe (included), Part No. 137-0872; refer to
Changing the Gearbox Lubricant (page
Drive shaft tool (optional), Part No. 137-0920; refer
to your traction unit Service Manual or contact your
authorized Toro distributor.
3
Use
19).
Advertisement
